Medical Skin Adhesive

Our Adhesi-Med (TM) skin-safe instant silicone adhesive ONLY

Tired of your favorite foreskin restoration device slipping off your penis? Do you have embarrassing or uncomfortable equipment malfunctions with your device falling down your pant leg onto the floor? Then you need Adhesi-Med to attach your foreskin restoration device and keep it from slipping off because typically just a gripper or cone just can’t keep your skin in place.

How It Works

Adhesi-Med becomes tacky upon contact with air, forming an instant and long lasting bond to skin. Adhesi-Med is made from scientifically advanced medical grade silicone polymer adhesive, and safe for use on skin. Contact silicone adhesives have wide use in hospitals by doctors and medical staff. We have adapted this medical technology for foreskin restoration.

Adhesi-Med forms a very tacky coating on any surface it’s applied to. In under two minutes after application, the adhesive is ready to apply to skin. Adhesi-Med forms a strong water and sweat resistant bond to your skin.  While the bond is strong, it’s still removable by gently peeling the skin off the device. The included Citri-Med remover eliminates any discomfort during removal and wipes away adhesive from skin and devices.

Device Uses

Adhesi-Med works with our Supercanister tuggers to eliminate the inner piece of tape. Simply apply a light coating on the end, allow to set, and roll skin up onto device. Secure with outer wrap of tape.

Adhesi-Med can also be used with bi-directional tuggers such as the DTR, TLCTugger, Tugboat, CAT-X, and retaining cones. Adhesi-Med can be used on almost any device to keep them secure from slipping off.

Note About Medical Skin Adhesive

People with extremely sensitive skin may find Adhesi-Med irritating if adhesive comes in contact with glans/mucosal tissue. We recommend that those people avoid getting adhesive on the glans. Instead, apply adhesive to device or shaft skin, allow to dry, then roll skin over device if retaining. Once adhesive fully dries it is pure silicone and should not cause irritation. We recommend first time users test a small skin area first. Adhesi-Med should not be irritating on external skin areas, however skin sensitivities can vary by individual and ADI is not responsible for skin incompatibility.

Common Questions About Using Adhesi-Med

How long does Adhesi-Med last?

It depends on several factors. If you apply it to a device and never remove the device, it would last a very long time. Adhesi-Med resists water, sweat, and body oils. It could last as long as several days.

If you remove the device and reattach it without reapplying fresh adhesive, you can get about 3-6 uses out of one application. With each reattachment the adhesive will lose some bond strength.

Another factor is the amount of weight or tension. Obviously more weight (>15 oz) will need good adhesive strength to prevent slippage. Adhesi-Med is up to the task !

Let’s say you were to use it on a DTR. If you apply the adhesive to the inner bell, you should be able to get 3 – 6 attachments on-off before you need to reapply more adhesive.

Keep in mind you only need a little bit of adhesive for most applications. When applying on a device, withdraw the brush from the bottle and wipe off most of the adhesive into the bottle. Just apply a very light amount around the device. Don’t over apply adhesive to avoid a excessive transfer to skin and a sticky mess.

Specifications

Adhesi-Med is a brush-on application. Brush-on applicator included. Keep bottle closed when not in use.

2 OZ (59ML) SIZE Adhesi-Med Bottle

Hundreds of applications per 2 ounce (59ml) bottle, it costs only pennies per day to use.

Contains silicon polymer

Once you try Adhesi-Med , you will say “It’s Truly A Miracle”

Adhesi-Med is a (TM) trademark of Advanced Devices Inc.